高速台钻具有多种用途，工零星和成批生产手表、仪器、量具、电讯器材、照相电影器材等用，特别适用印制板电路小孔加工。

Speed bench drill has applications in odd or lot production of parts of parts of watches,instruments,measuring tools,telecommunication eguipments, photoraphic and cinematic equipments etc,and especially suitable for drilling fine holes on printed circuits.

徐州店朱小姐0516-85020665 18951358764

技术参数：

钻削范围Drilling capacity：                                 0.6-6mm

主轴最大手动行程Maximum manua travel of spindle：            60mm                      

主轴头最大垂直行程Maximum shift tvavel of spindle：            90mm

主轴轴线至立柱表面距离Distance from the axis of spindle to the surface of column：145mm

主轴端锥度（莫氏1a短锥）Spindle cone(Morse taper 1a shors cone)：B10

主轴端面至底座工作面最大距离Maximum distance between the spindle nose to working：225mm

主轴转速Speed of the spindle：                               1500,3000,6000,12000r/min

主轴精度Precisionspindle：                                         0.01mm

底座工作面尺寸Dimensions fo working surface of the base：        250×230mm

电动机380V三相50赫兹0.3千瓦2800转/分Motor 380V 3Ph 50Hz 0.37Kw 2800r/min

净重（包括电机）Net weight(including motor)：                  ≈46Kg

外形尺寸（长×宽×高）Overall dimensions(L×W×H)：         560×270×530mm

使用

Operating

1. 本机床主轴箱的升降采用丝杆螺母机构。在调整主轴箱的位置时，应先用升降锁紧手柄（1）松开升降块（3），再用升降锁紧手柄摇动升降螺杆使主轴箱升（或降）之所需要的位置，然后再将升降锁紧。

Lead screw and nut are used for lifting and lowering the spindle head . In adjusting the position of spindle head ,locking biock(1)must be loosed with the handie(3)first, then lift or lower the spindle head to desired position through turning the handle after fit it back on the top pod of the lead screw,and lock up the locking block finally.

1. 本机床采用标尺定深机构。定深时可先转动粗调旋钮（5）调至所要的位置，然后转动细调旋钮（7）进行细调。

A staff gauge is used to control the depth of drilling hole .The drilling depth

Can be abjusted by coarse adjusting knob (5)and fine abjusting knob(7)one after another.

1. 平皮带松紧的调节，应先松开紧定螺丝（2）,推动电机机座底板，使皮带松或紧到需要的程度，然后在拧紧紧定螺钉。

In adjusting the tension of belt, loose the screw(2)first,then push or pull the base plate of motor, and tighten up the scrow finally.

1. 主轴的变速是靠调换平皮带的位置获得的。

Various speeds of the spindle are resulted from changing the positiong of belt on them.